g4 install on 1995 nissan s-14

[clearview]

i am installing a set of g4s on my 1995 nissan240sxse [s-14].
i will be mounting the set using nissan parts. do i use part # 55248-2y000[ COVER ASSY] on the install. this part is listed as a [plate ]in the nissan shop manual. in the stock setup it goes between the dustcover and lower bushing. on the g4 install this part causes poor fitment between the g4 upper mount and nissan upper rubber seal part#55034-60u05 and upper spring seat.part#55322-70t00.
thanks for your help Bill

[Peter]

G'day Bill,

I have replied to your earlier email and indicated that I?m not sure what the actual problem is.

Item 8 is a washer that locates between bump stop Item 9 and top mount lower bush Item 7.

The Group'4 rear strut is supplied with a washer that can be used to replace washer Item 8.

Parts 6 and 7 are factory components, so I don't understand why there is a problem with them. They must be reused.

Regards

Peter
peter@whiteline.com.au

[clearview]

thanks Peter . leaving that one piece out on the reinstall makes for a good fit.
Bill

[Peter]

Good to hear Bill,

Now all you need is to set the ride height and get an accurate wheel alignment.
We suggest you start with the ride height listed for the control springs and wheel alignment figures suggested in the Fact Sheet.
Swaybars. We suggest you start with the rear bar on full soft (outer hole) and the front bar on the middle setting or as for the rear bar on full soft and start from there.

Enjoy ;)

Peter
peter@whiteline.com.au